* *
 |
|
| |
Propel Support
Norton Personal Firewall
When you first install and run Propel Accelerator, you will receive
several security warnings. One warning in particular will have the
title, "Program Control" along with "Medium risk - PropelAC.exe is
attempting to access the Internet. What would you like to do?" Below
this, it will give you the default setting of "Block" in a pull down
menu. To allow access to Propel, you must change this to "Permit" and
then click "OK". This message will come up a few more times and you need
to perform the exact same steps on each one.
If for some reason, you have blocked "Access to Propel Accelerator" and
are not able to surf the Internet after installing Propel, you will need
to manually configure access to Propel Accelerator. To do this, perform
the following steps:
1. Right click on the Norton Personal Firewall Icon in your system tray
near the
clock.
2. From the menu, click on "Norton Personal Firewall". This will open
the
Norton Security Center.
3. Click on "Personal Firewall".
4. On the right hand side of the window, click on "Configure".
5. Click on the "Program Control" tab.
6. Scroll down the list of programs and select "PropelAC.exe".
7. Click on "Block All" in the pull down menu and change it to "Permit
All"
Click on "OK".
8. Start Propel Accelerator if it is not running. Go to Start> Programs>
Propel
Accelerator and choose "Start Propel Accelerator". You will
now see the
Propel Icon appear near your system clock. |
| |
|
